Tutorials

Packing List

The packing lists are as follows.

①Connect ②Phone Holder ③Device Cable ④Mobile Cable ⑤Power Cable

Hardware Connection

Connect the 3DMakerpro Connect to the scanner with the device cable; connect it to the phone with the mobile cable; connect it to the power bank with the power cable. In this case, we use Mole(as shown in the pic), and the connection logic applies to all the compatible scanners. Notice the power bank needs to be purchased by itself, and the requirements are: 12V PD 22.5W Type-C interface.

＊ Device Cable

Please make sure the red dot on the plug is lined up with the groove on the device port in case of causing damage to the device. Be sure to plug and unplug the cable in the power-off state.